Hello all thank you for helping with the bed level issue. I haVe that fixed, but now having a new problem. I had to remove the carriage for the extruder because the cable was tucked under the bed and I did not notice. So I loosened the top two wheels to remove it. I removed it fixed the cable and put it back together. Now the wheels will not tighten enough to keep the carriage on track. Not sure exactly how this fucked up. I mean it’s 3 pieces. A screw, spacer, and a nut. I cannot figure out what the hell is going on here. Is there a piece I wonder I missed that fell or something that secures it tighter. Well if anyone had an idea I would appreciate it. Thanks again.