I modeled and printed this super hero girl on my Sonic Mini and it looks great but I kinda failed at designing the cape to fit properly. As you can see one side is up off her shoulder, which makes no sense and on the back the cape really should be draped over her leg but is a little above it. The resin does have a little flex to it but it springs back after bending it. The cape is not glued on yet so I was wondering if it's possible to put it in hot water or something then bend it into place and hold it until it cools. Pics attached. Ignore my wood filler that I'm using to fill the seams.
20200525_040953.jpg20200525_041019.jpg