Close



Results 1 to 2 of 2
  1. #1

    X-Smart and heat creep problem

    Hi,I am new to 3D printing and am playing with my new acquired X-Smart. I am using Qidi standard supplied PLA filament.I have done the test example, and that worked fine. Also tried a few other examples.However I have gone for a bigger piece and now I am clogging up every time with heat creep causing the filament to melt ABOVE the nozzle in the feeder area.Any specific advice for a n00b using an X-Smart and having this issue? Might I have reassembled the whole nozzle etc incorrectly?Hints or tips on settings?Thanks

  2. #2

    Surveys Information

    If you are a customer of Publix then you must take part in the Publix survey cause Publix organized. https://surveysguide.onl/

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •