Hello fellow printers,I recently swapped to a Borosilicate glass to get my prints to have a little smoother finish. Since then, it takes forever to get a good ABS print. When the extruder moves over the glass, I don't see much filament extruding for the first 3 layers. So I'll lower the bed on the next try and I'll see some come out when printing but its uneven. I've always been told that when you level the bed and use the paper that it's supposed to almost rip the paper when you pull it out. Almost. Is it a different method when using Bososilicate glass? Granted I don't print with ABS very much, mainly PLA. Just wondering what you all thought. Any help is accepted, also appreciated. Print temp: 140Bed temp : 110FlashForge Creator ProStock nozzlesABS