Results 1 to 2 of 2
Threaded View
-
04-06-2020, 08:23 PM #1
- Join Date
- Mar 2020
- Location
- Ceciltucky
- Posts
- 12
Help Plz - Tronxy X5SA Pro - The need for speed!
So I printed this calibration cube and it took 40 mins! It's only a 2cm cube that Cura estimated would take 18 mins.What's in the world is going on? Below is a pic of the recommended settings and the cube..
What settings should I be looking at to change this? Or is it a problem that I need to change in the firmware?
cali_cube_setting_cura.JPG
cali_cube_pix.jpg
40mins.JPGLast edited by crabjoe; 04-06-2020 at 08:39 PM.
Extruder not feeding during print,...
04-28-2024, 02:02 PM in Tips, Tricks and Tech Help