Results 1 to 1 of 1
-
03-13-2020, 03:10 PM #1
Printer question, im a new noobie
Hello everyone i feel honored to be here. I have a few questions and i would like your your opinions on if i'm doing this whole 3d printer thing correctly since i'm a noobie.
For my first printer i'm looking at the, Artillery Sidewinder X1. I made this decision from watching Makers Muse on youtube.
As for filament. I was going to go with IC3D PETG until i read about Amphora and now my sights are on ColorFabb nGen filament.
For the software i was thinking of using three. Blender, Slic3r and Meshroom.
What do you all think? thanks
Do bed magnets deteriorate.
04-29-2024, 01:35 AM in General 3D Printing Discussion