Results 1 to 2 of 2
Threaded View
-
02-21-2020, 04:39 PM #1
- Join Date
- Feb 2020
- Posts
- 1
Hello.......can somebody explain why the print is doing this?
Hello, im fresh to the forum and also to 3d printing as this is my second attempt. I'm running an ender 3 with the creality filament and using cura as the slicer.
I noticed that one end of the print is a bit skewed and the circle on the first pass had lifted.
I ran the bed level g code from Chip and looked to work ok, but dont know why a print would do that unless there is something wrong in the setup.
Any advice would be greatly appreciated.
Do bed magnets deteriorate.
04-29-2024, 01:35 AM in General 3D Printing Discussion