Hi folks,

First time here, hopefully this is the right spot for this sort of question.

I have an Airwolf Axiom, about 4 years old but not a lot of miles on it. It’s just not a very good printer, unfortunately. I’ve decided I’m going to bite the bullet and overhaul it.

The main issues, in my opinion, are the hotend and the extruder. Lots of jamming. Extrusion issues.

My current idea would be to replace the hotend, that seems straightforward enough, and convert it to a direct drive system, keeping the motion system intact.

Feasible? Anyone have any better ideas?