Results 1 to 1 of 1
-
12-20-2019, 05:38 PM #1
- Join Date
- Dec 2019
- Posts
- 4
Over Extruding with an AnyCubic Mega S and Cura 4.4
Hello forum.
I am new to 3D printing and have had reasonable success with printing small miniatures (something with not much surface area).
However, I have been trying to print something with a bit more width and I have an issue (that was also present with my earlier prints, but did not cause so much of an issue as they has a small surface area).
The issue is that I seem to be extruding when the print-head is moving to its next position. I have spent a lot of time ensuring that the print bed is level and clean. I have adjusted the 'Retraction' configuration within Cura but to no avail.
The printer is an AnyCubic Mega S with the supplied 1.75mm filament.
Any help or pointers will be gratefully received...
Harold Clements
Ender 3 Neo - Jam Problem
Today, 12:39 PM in Tips, Tricks and Tech Help