I cannot post a link yet so...if you youtube "3D PRINT THORN" and select the video by "3d printing nerd"....then skip to 2:00 you will see the section I am having a hard time with. It is NOT my print/printer, but its the only image i have of what I am trying to print.

I am having an issue getting the support material that shows up to the FAR LEFT (that little spike) to stick to the bed. The rest of the print is perfect and clean, but this part always pulls up or bunches up.

Things I have tried:

- Raising/Lowering the extruder/bed temps
- Slowing down the initial layers
- Leveled the Bed (I have done this a few times). Bed Leveling test prints come out GREAT
- I have even rotated the print so that this piece is in different corners of the plate

Doesn't matter what I do, I cannot get that support material to stick.

Suggestions?
Can I maybe increase the support pattern % to create a more compact support section?
I am also considering a RAFT to get it to stick. And this, for me, is desperate.

Again the REST of the print is perfect. Even the other places that start with support material. But that one spot isn't sticking.