Close



Results 1 to 4 of 4
  1. #1

    3D Printer in Education Spool/Filament Changing Questions/Survey

    Hello all,

    I am new here and part of a project team in a summer class and we are research filament/spool changing times and potential safety related issues pertaining to the education (k-12 and college/university settings) 3D printer world. Any information, opinions, and thoughts related to the amount of time it takes you to change spools/filament and what type of 3D printer you are using would be greatly appreciated towards our project. Thank you, in advance!

    Sincerely,
    LehrerJeff

  2. #2
    Reply teacher domyhomeworkonline

    Hello,
    We divide our work activities into 4 steps (college level):
    Pre-printing
    Printing
    Post-printing
    Maintenance and cleaning
    You may see the details of each step in the brochure by NTRC: 3D Printing with Filaments: Health and Safety Questions to Ask

  3. #3
    1) First, connect the 3D printer to the source and warm up the extruder to operating temperature. The extruder heating temperature should be the same as the printing temperature for the specific plastic.
    2) Hold the lever of the pressure mechanism and slide the thread forward towards the nozzle until the plastic starts to come out of the nozzle.
    3) And take the plastic rod out of the extruder with a sharp upward motion in the opposite direction.
    4) Now you can start loading the new filament.


    After installing the new plastic coil for 3D printing, I recommend to print a test model to normalize the filament feed.

  4. #4
    Replacement process:
    1. The extruder must be switched to the "Service" mode by means of the control panel. For this purpose, the button 4 is used;
    2. Carefully remove the channel tube from the extruder by pulling it upwards;
    3. to pull the bar out of the extruder, you need to press the clamping mechanism gently and slowly pull the bar upwards.
    4. Place a new coil and pull the plastic through the channel tube;
    5. After loosening the clamping mechanism, press the bar gently and gently;
    6. Insert the channel tube into the extruder;
    7. Then it is necessary to draw the filament, about 30-50 units, immediately removing excess plastic. This action is performed using the RepetierHost control panel.

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •