Close



Results 1 to 1 of 1
  1. #1

    Need some help configuring Marlin for a custom, rebuild Cubex Duo printer

    Hi,

    Ive been working off and on for the last 5 months on converting an old Cubex Duo printer into a RepRap (Marlin) printer. This is mainly due to the fact that the software on the printer before was proprietary, and was limited to how/what slicers I could use. So, I gutted the electronics and replaced the mainboard with an MKS Gen L and fitted the XYZ drives with TMC2208 and the extruders with A4988. I also added a BLTouch clone (3D touch) to the system as well.

    This is not my first 3D printer per say but the first time configuring from vanilla Marlin. There is a lot of extra space inside the cube this machine occupies due to the dual extruder setup and also that it has the ability to use a purge bucket (not sure about that one yet; going slowly). What I'm stuck on trying to figure out is how to best use the negative (non-print bed) space of the frame to maximize the build volume, but also get the best results when probing the bed with the probe. What settings would I need to modify in a Marlin 1.1.9 build file in order to ensure that the carriage head moves to the right positions of the bed? Also, I can't find much documentation on the 3D touch ABL sensor and wasn't sure how high to mount it from the nozzle.
    20190601_121943.jpg20190601_121951.jpg
    Any help would be great. I have the system itself moving and homing with a mechanical Z stop switch so that part works fine; just want to get it where I want it.

    Thanks,
    Last edited by drock1985; 06-01-2019 at 11:45 AM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •