Results 1 to 2 of 2
-
01-28-2019, 10:48 AM #1
- Join Date
- May 2017
- Posts
- 2
ZD-ONE 3D Printer doesn't work.. please help
PLEASE...I NEED HELP
I have 2 of these printers. I cant make eather of them work. I have set them up correctly, but when i unzip the files it is always giving me an prompt bar that states...
"Please insert the last disk of the multi volume set and click continue"...
I dont know what that means nor can i find it in the software. I am able to bring up the cura and load the test file into it. It will slice it and allow me to save it to the SD card. I load the sd card into the machine and once i press the print button on the lcd display...it will let me choose the file, but once i confirm to print, the machine just sits idle. It will not go into heat up mode...and it will not move. I have tried to manually heat everything up but that still dose not work. The percentage bar will be going through from 1-100% and still nothing happens even after that.
Eather im missing something here or this set up just dose not work.
-
01-31-2019, 09:40 AM #2
any idea what firmware you have ?
the control panel on the printer should tell you.
At the end of the day it's a bog standard i3 printer, so most i3 profiles for cura should work.
just need to know what firmware the board is running to get the right i3 profile.
New to 3d printing looking for...
Yesterday, 12:56 AM in Tips, Tricks and Tech Help