Results 1 to 4 of 4
Thread: The power of Acetone
-
06-14-2014, 12:39 PM #1
The power of Acetone
Hey guys,
I would like to open a topic here where we can share our experiences with Acetone and your prints,
As its a fun method that cleans your prints marvelously,
So far i have done it a few times, Always at 110c on my heatbed and a simple glass container with a lid.
https://www.dropbox.com/s/papnwqltsq...2019.31.15.jpg
https://www.dropbox.com/s/4metufsf1f...2019.31.30.jpg
https://www.dropbox.com/s/papnwqltsq...2019.31.15.jpg
-
06-15-2014, 02:43 AM #2
There's nothing worse than being beaten half to death by raggedy edged knuckledusters.
OME
-
06-15-2014, 06:08 AM #3
Hey it was just nice to print xD
Its not like i would beat anyone, Not even with a 3D printed one,
Btw who said it was actualy the size you would think it is? :P Could be a mini one ^^
Anyhow :P
I knew someone would say that, but from you Old man emu?!
haha :P
-
06-15-2014, 04:45 PM #4
Ha Ha! That was the product of a nearly deranged mind. I had just come back from wrestling with a print for a few hours and my mind was letting off built up pressure.
Actually, I have been smoothing some prints by lightly painting them with acetone and letting it evaporate off. Probably not very effective in terms of wastage of aetone.
OME
Ender 3 Neo - Jam Problem
05-08-2024, 03:06 PM in Tips, Tricks and Tech Help