I have had my Ender 3 for about 2 weeks now. It was a pretty easy setup and after a few learning curves my prints started turning out good. I have added the Creality Glass bed, and some of the recommended print upgrades. now what am printing I keep having these same problems.

Print Settings
Nozzle .4mm
Layer Height .2mm
Wall Thickness 1.5mm
Infill 10%
Print Temp 200
Bed Temp 70
Retraction 5mm
Print speed 40mm/s

https://www.dropbox.com/s/h5q0snh7x4...%2033.jpg?dl=0
Picture 1. Is this normal for the brom to be "loose" like this?

https://www.dropbox.com/s/cw6xtb2xxg...%2015.jpg?dl=0
Picture 2. You can slightly see how some of the layers are offset from the rest, and then it seem to correct itself. You can also see how the brim is starting to come up.

https://www.dropbox.com/s/56dcmu88h1...%2019.jpg?dl=0
Picture 3. Here the sides of the actually print are coming up.

https://www.dropbox.com/s/fu8pdk46bl...%2041.jpg?dl=0
Picture 4. here you can see after i stopped the print how the bottom was flat but the ends where curling up.

https://www.dropbox.com/s/7vqz6epto4...%2008.jpg?dl=0
Picture 5. This is the other side of the same print. the whole thing is suppose to be the same thickness, but as you can see it tapers off.

Thanks for your help