Results 1 to 5 of 5
Thread: Extruder heat lagging
Threaded View
-
05-22-2014, 07:35 AM #1
- Join Date
- May 2014
- Location
- Fishers, IN
- Posts
- 22
Extruder heat lagging
I've got an issue where the extruders actually heating up is severely lagging behind the input for heat upon warm up. I don't have any issues once the machine is up to temp and running.
I've got the standard Flashforge Creator dual head and I just upgraded the firmware last night to Sailfish v7.5 via Replicator G which had a note that it addressed extruder lag. I've also only operated via USB so far.
If I use the control panel, I do see the commands for temperature and the bed heats up, but the extruders just have a massive delay until one starts heating up, then the other gets going. I also seemed to notice, maybe a coincidence that as soon as the fan's turn on, the last extruder to be lagging starts going.
Is there a deeper diagnostic tool I can use to try to sort out where the problem is, like seeing if the board is actually making the command for the heaters to turn on?
Ender 3 Neo - Jam Problem
Yesterday, 03:06 PM in Tips, Tricks and Tech Help