Hello

I am new in the 3D printer community, and does not know a lot about 3D Printing so far.
I am currently using an Ender 3 3D Printer with PLA filament. I am using the recommended settings on Ultimaker Cura 3.4.1.

I tried to print a one-hand book reading accessory from thingyverse, and it made this weird "offset" in the layers. (Images below)
- I am not quite sure what causes this. I thought it might be bad G-Code but i am not sure.

Hopefully someone in this forum knows what went wrong.

Higher quality images:
https://i.imgur.com/IMfr5vG.png
https://i.imgur.com/nm1FYU0.png
https://i.imgur.com/ijMH985.png

Thanks
ijMH985.jpgIMfr5vG.jpgnm1FYU0.jpg