ABS Warping

[Firepower]

I have been 3D printing and making a mess for years until I installed Cura from the manufacturers site and now things are much better. My printer is a Cocoon Create and for ABS I put the temperature at 245 degrees and 95 degrees for the bed. So this may be wrong?

There is still two things I need more information on.

1. ABS lifting on the ends. PLA prints good but ABS lifts up at the ends. My printer now lays down a wider brim for the item to sit on and the border sticks good but the print lifts off the wider brim, as per the photo.

2. Is there anything special to do when items span a wide area and it just does not print properly, as in the photo. I will try and print it vertical.

Any comments would be appreciated.


EDIT: I just noticed someone advised this for ABS years ago so I'll try those temperatures. "Change your temp to 230c and 110c for the hotbed".



ABS Lifting.JPGUnsupported Mess.JPG