My First Project

[Roberta3D]

I wanted to share with you the results of my first 3D printing experience. The red Eiffel Tower was my first attempt at using this technology. (I know, I am behind). It is 9.5 inches tall and it took me about 7 hours to print using the Titan 1. I printed a smaller version too, which is also featured below. I was shocked by the detail on the smaller model.

IMG_1509.JPG



IMG_1513.jpg



Any suggestions for what I should try to print next?

[AndrewK]

Very nice detail. Which printer did you use? Do you have any larger photos?

[Roberta3D]

DSC05353.jpg

Here is a bigger pic. I am new to this, so bear with me while I figure out how to scale my photos.

[Roberta3D]

DSC05355-1.JPG

It looks like it worked! Here is a close up!
DSC05252-1.JPG

Here is an artsy picture of it.

I used the Titan 1 by Kudo3D. It hasn't been officially released yet, not until May 20th, but I was fortunate enough to procure a prototype.

[old man emu]

I wanted to share with you the results of my first 3D printing experience. Any suggestions for what I should try to print next?

OK. You have your 3D printer and you can see that it works. But it is just a tool to be used to express yourself. Use your imagination. What things are you interested in? Design and print those. Try not to be a mindless replicator of other people's designs. (But sometimes you have to for the sake of time and convenience)

Old Man Emu