Results 1 to 1 of 1
-
01-17-2018, 12:31 PM #1
- Join Date
- Feb 2017
- Posts
- 79
Maker select, no usb all the sudden
I did all the diags
1. Different USB port, different cable, different pc. All are now showing Unknown USB device (Invalid configuration descriptor). Tried to install the arduino drivers again and no dice. Anyone else run into this before? Suspect the internal usb controller in the printer took a dive but hopefully not. I did remove the reset jumper some time ago as well so that isn't a fix for me
Do bed magnets deteriorate.
04-29-2024, 01:35 AM in General 3D Printing Discussion