Subscribe to Our Newsletter Advertise
Close



Results 1 to 7 of 7

Threaded View

  1. 10-20-2017, 01:28 PM #1
    cwess351
    cwess351 is offline
    Student
    Join Date
    Oct 2017
    Posts
    2

    Edges Messy and Curling

    Full Print: https://imgur.com/iijCv87
    Half Print: https://imgur.com/boEjGDY

    Here are three calibration cubes that I printed and their issues. Most of it looks good except the details on the X and the ripples moving up and down the sides of the walls (which is not as bad in person as it looks on photo). Im more concerned with the details on the X and cant figure it out.


    Print Settings:
    https://imgur.com/a/FCrda

    Advice is greatly appreciated! Poor filament? Slicer Settings? etc?
    Last edited by cwess351; 10-20-2017 at 02:11 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules