Hi!

I have setup my first 3D printer. The TEVO Black Widow.

The frame was solidified using cast brackets and printed extra corner supports.
Bed was leveled and working BLTouch was setup

The three prints are done with the same settings in Cura 2.7.0. The only difference is the small 10mm die was printed with 0.1 layers

Please help me fine tune my prints as I am not longer sure if it is mechanical or my settings that cause all the small issues you can see.

ThanksCube.jpgIMG_20170911_133115.jpgIMG_20170911_133154.jpgIMG_20170911_133131.jpg