Close
Flash Forge Inventor Series



Results 1 to 2 of 2
  1. #1

    Unhappy Extruder problem

    My left extruder has stopped working. It was fine during one session, then it wasn't. I have tried unloading the filament (PLA) and reloading it, but there has been no difference. Does anyone have any suggestions on how to proceed? I have a FF Creator Pro.

  2. #2
    It's OK now. I had to dismantle the extruder and remove the gob of filament. Learned a lot about my printer!
    Thanks.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •