I'm working on my first single-plate Prusa i3 build and purchased an aluminum frame and parts kit from a supplier in Spain. The supplier assured me he was using the most recent BOM, however the Y-axis corners he sent have an M8 center hole instead of the M10 that's specified in the RepRap wiki build manual. I've already got all the rods, so I'd rather just swap out the printed parts.


He's willing to ship me new parts, however since he's in Spain the cost of shipping alone is $30 to $40 (I could literally buy a whole new parts kit off eBay for that much.)


If there's anybody who could print these, I'd be happy to pay you - as long as it wasn't forty bucks.


Any help would be greatly appreciated!!!


Thanks!
David