Subscribe to Our Newsletter Advertise
Close



Results 1 to 4 of 4

Thread: Printer Died

Threaded View

  1. 03-21-2017, 11:32 AM #1
    athlon2k2
    athlon2k2 is offline
    Student
    Join Date
    Dec 2016
    Posts
    10

    Printer Died

    So I have a Monoprice Maker Select 3D. I started smelling something burning and then the display started flashing and now it won't turn on. I'm assuming it has something to do with controller. After pulling it apart I see that the power cables (specifically the ground) is chard inside the connector and no where else. All the other components are fine and the smell was definitely coming from there. Any ideas what the heck happened? I am going to test the output of the power supply to the board now.

    IMG_1775.jpg
    Last edited by athlon2k2; 03-21-2017 at 04:55 PM. Reason: typos
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules