Subscribe to Our Newsletter Advertise
Close



Page 2 of 2 FirstFirst 12
Results 11 to 12 of 12
  1. 04-30-2014, 01:06 PM #11
    KrypTONight
    KrypTONight is offline
    Student
    Join Date
    Apr 2014
    Posts
    23
    I've actually had this happen to be before too. Luckily I was only in the other room, and I caught it before it caused any major problems.
    Reply With Quote Reply With Quote
  2. 05-13-2014, 11:49 AM #12
    CaptainObvious
    CaptainObvious is offline
    Engineer-in-Training
    Join Date
    Mar 2014
    Posts
    223
    I just noticed that Slic3r writes the volume of filament used on the GCode, it's at the end of the print code, before the settings section. That makes calculating the weight of filament needed for a print much easier.
    Reply With Quote Reply With Quote
Page 2 of 2 FirstFirst 12
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules