It was printing perfect for about 10 prints and then this (See pics) I'm beyond frustrated at this point. I'm printing w/ PLA. I'm using the bed cover piece that came w/ the printer. I've tried re leveling the bed using a piece of paper w/ slight drag at 6 points, a bunch of drag and zero drag and it has not made any difference. I've tried 3M tape w/o any bed heating, I've tried different bed temps from 50-70 w/o any change This is the initial layer so the print speed is 30mm/s. Infill speed is 100mm/s. Initial layer thickness is .3mm, initial layer line width is 100%. Bottom/top Fill is .6mm, Shell thickness is .8mm. I need your expert opinions to figure this out. The print head cooling fan is on but the fan at the very front of the printer is not on but it never was even when it was printing perfect.

2017-02-26 00.12.20.jpg2017-02-26 00.11.56.jpg2017-02-26 00.10.53.jpg

Thanks much,

Dave