This GEEETech i3 is all back together and up and running at 24v. The LM2596 step down converter don't lie(by more than 1/2 a volt)..



Here is the new titan aero clone extruder setup all powered up and ready to go..



I now have this same extruder and layer fan setup on all 3 of my printers. I can't say enough good things about this setup..



I also upgraded the belts on this machine to the gates fiberglass reinforced gt2 belts and swapped the smooth idler pulleys for toothed idler pulleys. Here is my GEEETech prusa i3 all together and ready to print again..