I have a question about support material. I have a design that relies on the support material in being a part of my design and, not knowing much about the printers process and slicing software I am curious as to how the peachy generates the support material.

So my question would be, does the peachy printer use the same support material structure as an FDM printer? so will it create it at each layer, and will it use just as much material?

for example I have a cube, with the top and bottom removed. The cube then has an offest roof. will the peachy printer want to build support material underneith the roof, does it need to? and will it do it in the same way as an FDM printer? second to this. could you control the support material area. could I tell the printer where I want the support material to be and change the density by percentage?

Thank you
-Chris