Originally Posted by
threedee4me
i am a new so i am going a mile a minute trying to soak up all info i can. i bought simplyfi3d but that has my head spinning in good and bad ways since there are so many settings its great but confusing to me too. the print came out much better but there are still imperfections. i see some holes at the bottom of the print. i was about to try to add more perimeters first using the software. i will 100% take your advice and try it again your way now instead first.
its makergeek clear pla. it says use at 230 since its a very concentrated color and its nearly pure pla resin. i will try and see what i get.
thanks
Do bed magnets deteriorate.
04-29-2024, 01:35 AM in General 3D Printing Discussion