i cannot for the life of me figure out what i am doing wrong on this.

- pla
- flash forge finder printer
- tried flash print stock settings: with rafts and supports
- then i tried simplyfi3d and messed with extruder multiplier stock is .90 i tried .95 and .100 to no avail. the temp was set 210 i raised it to 220 to no avail




i am now trying the same print in simplyfi3d again with the same pla filament but a different color and its seems to be working. could it just be a bad batch of filament? if so can i change setting to compensate or its just bad?

thanks