prusa i3x automatic bed leveling issu only one point

[tropax]

hi im having problems With making my printer auto leveling.
ive installed a sensor and updatet the firmware and removed the // for the auto bed leveling but the sensor only gode to almost senter of the build plate and checks that spot. i wantet 4 or even 9 point.
is there somthing im missing?

its a geeetech prusa i3x

[AutoWiz]

Hello. I, too have a GEEETech prusa i3. mine is the clear acrylic pro b or c. These are great little printers. I hope you have gotten as much use out of your as I have gotten out of mine. I made a whole thread on the things that I have made with my geeetech i3. if you care to see, it is here:
http://www.digitalcorvettes.com/foru...d.php?t=270130
The greatest feature about these printers is their flexability and upgradeability. I have been chasing down multiple and mixing extruders and higher definition in prints with drv8825 driver modules and .9 degree stepper motors. I have not gone after auto bed leveling, yet. But when I am ready for it, I am sure I will rely on this video to show me how:
https://www.youtube.com/watch?v=EcGFLwj0pnA
this guy has a lot of tutorials on youtube. they are all very good and very informative videos to watch.

[tropax]

Hello. I, too have a GEEETech prusa i3. mine is the clear acrylic pro b or c. These are great little printers. I hope you have gotten as much use out of your as I have gotten out of mine. I made a whole thread on the things that I have made with my geeetech i3. if you care to see, it is here:
http://www.digitalcorvettes.com/foru...d.php?t=270130
The greatest feature about these printers is their flexability and upgradeability. I have been chasing down multiple and mixing extruders and higher definition in prints with drv8825 driver modules and .9 degree stepper motors. I have not gone after auto bed leveling, yet. But when I am ready for it, I am sure I will rely on this video to show me how:
https://www.youtube.com/watch?v=EcGFLwj0pnA
this guy has a lot of tutorials on youtube. they are all very good and very informative videos to watch.

Nice thread you have.
mine is now just a bunch off wires for now , becaus im constantly changeing and testing warius Things. that last steep was to get the auto bed leveling working before i installed the 2nd hott end for the dual extrution.
but still there must bee somthing im doing wrong. it only probes ca. the center of the plate. i want atleast 4 spots.

i havent had time the last weeks to play around With it, but im hopeing to be able to have a look again soon.
youtube i a great sorce for Learning and diy on the printers . i beleve im doing everything like they exept diffrent walues becaus of my placement of sensor and hottend