Hello all, I have a Da Vinci printer on the way and have run into a problem. I was given a couple of spools of filament from a buddy that he extruded so I didn't order any of the cartridges for the printer. My question for the more tech savvy people out there is, is there a way to reset or hack the chip in the cartridges so I can have a wider range of options for filament? I know if you have a full cartridge in the printer and feed a different spool of filament into it, it will print fine. The problem comes when the printer reads that you have gone through the amount of filament in the cartridge, it stops and you have a full cartridge that reads empty.