Ordered some black ABS and having a really tough time trying to figure out the right settings to print with. I keep getting goopy/sloppy prints. I've played with extruder temps from 226 down to 200, BP temps from 110 to 100, I keep my feedrate at 50 and tool feed at 80.

Any thoughts? Bad ABS?

I've done much better with white ABS and I've heard that was the tricky one to deal with....

Also I've noticed at lower extruder temps but even with a 110 degree BP the edge curl is insane. Currently using masking tape instead of kapton for the build plate coverage. The kapton had some air bubbles in it from the factory.