Hey guys,

As everyone knows PLA and ABS are great plastics with both there cons and negatives,

Now i'm trying ABS for a few days now when i am pretty known with PLA,

With small parts ABS works GREAT, But once i am like at 100mm for example its starts to warp,

It used to only warp at the bottom due i used Hairspray as i did for my PLA parts, So i went and made some ABS glue,
This was a great improvement, It didnt warp anymore from the bottom,

But now it started to rip parts of some layers apart,
Like in the middle of a print, it has a rip in it, Not the whole print layer but a side of it.


Anyone a idea how to fight Warping?

My room temprature is aprox 20c,
Its next to a heater, so i could tune that a little up, But the wood were the makerfarm is made from could always warp due sudden heat i guess.

My print head is at 225c and bed 105c.


Thanks guys ^^

Best regards,
DrLuigi.