Castle GraySkull Print

[Geoff]

Printing out another fond memory from my childhood.. "By the Power of Grayskull!!"

Printed on my trusty Flashforge 3D
Filament - Snow White
Nozzle: 230c/HB 110c
70ms Feed, 110ms Travel
0.25mm.

Printing time rundown
The two towers - 4 hours
The skull main piece, 2 hours
The Base Arch with rocks , 3 hours
The door, 30 minutes
Skull cap 40 minutes
Logo Rock with text, 1 hour.

Total, approx 12 hours.

[RobH2]

That looks pretty nice. Did you have support material in the mouth? Cleaning that out would be tough without damaging the teeth. The text printed well too. I'm surprised at how clean the print is at 70ms. Nice...

[Geoff]

That looks pretty nice. Did you have support material in the mouth? Cleaning that out would be tough without damaging the teeth. The text printed well too. I'm surprised at how clean the print is at 70ms. Nice...

No, none at all, the only support was on the inside of the arch in the doorway. I printed the skull upsidown on the flat area of it's head, the only support was the raft I used, otherwise the teeth printed without any supports at all, there wasnt alot of cleaning up on this to be honest.