I realized there was something off with that first print and my bed ended up being un-level. The spots that look like high spots are where there starts to be an overhang and there is no support underneath. The material just curls up in those spots with no support. I am using a printrbot simple with painters tape attached to the bed and do the calibration instructions before each print. I was able to set the Slic3r to raise slightly each time it traveled to keep from hitting those spots and tried the dog again after leveling the bed. It's not perfect but here's what I got:IMG_20140314_203745319.jpg

I printed this for the Y axis right after: IMG_20140311_124142963.jpg