Hi am having issues with the X Y Z axis’s, when I jog the axis’s they move but make a loud noise and stop the start again and so on till they reach their desired position but when I press home they move without issue then after homing the axis's X Y axis’s jog fine but Z still makes a loud noise and starts and stops, voltage for the pots are all within suggested range .39-.50, also prints without issue but after printing when the axis's are meant to return to X0 Y0 and Z250 the issue shows up again as shown in linked video. at a total loss as to what is causing the issuehttps://youtu.be/_Alf9k_CBLU