Results 1 to 1 of 1
Thread: Heatbed consistency
-
03-31-2016, 04:13 PM #1
- Join Date
- Oct 2014
- Posts
- 134
Heatbed consistency
The heatbed on my 10" i3v varies in temperature as much as 15° C from one area to the next. This is measured with a Fluke 62 MAX Infrared Thermometer, so the accuracy is not at question. The very center of the heatbed is the hottest, dropping off as it gets closer to the edge.
Is this normal, or should I be getting a new heatbed?
Do bed magnets deteriorate.
04-29-2024, 01:35 AM in General 3D Printing Discussion