Results 1 to 5 of 5
Thread: AutoHome vs ABL Z axis Height
Threaded View
-
03-06-2016, 06:14 PM #1
AutoHome vs ABL Z axis Height
Hi, Using the beckdac / Marlin code, if I do an AutoHome and then move the Z axis to zero the nozzle is 4.1mm above the glass. If I then do an ABL and move the Z axis to zero the nozzle is exactly where it should be.
I am assuming (probably a mistake) that the configuration.h value Z_PROBE_OFFSET_FROM_EXTRUDER is used for both ABL and AutoHome? Is there another value that would affect AutoHome but not ABL that could cause this discrepancy?
Ender 3 Neo - Jam Problem
05-08-2024, 03:06 PM in Tips, Tricks and Tech Help