Results 1 to 2 of 2
-
02-23-2016, 08:56 PM #1
- Join Date
- Feb 2016
- Posts
- 2
Gap between infill and shell Replicator 2
My Replicator 2 has been printing flawlessly for a long time and them the hot end unit went bad so I ordered a new one and installed it and now all my prints have a gap between the shell and the infill. The odd thing is the gap is only in one axis. I printed the same part twice (at the same time and turned on 90 degrees to verify and the gap is on only one axis. At the same time I got a new laptop so I installed the latest version of makerware. I have uninstalled and tried makerware version 3.6 and 3.7 and 3.9 without improvement.
If I turn the part 45 degrees is only happens in the corners. Did installing a new hot end and nozzle cause this??? How do I correct this error? Is there some sort of calibration I need to go through.
gap1_zpssofh2nl5.jpg gap2_zpsy1h5s0dn.jpg
gap31_zpsnhvnkgsr.jpg
-
02-24-2016, 06:35 AM #2
- Join Date
- Feb 2016
- Posts
- 2
Anybody have any suggestions?
Please explain to me how to...
Yesterday, 03:08 PM in 3D Printer Parts, Filament & Materials