Kind of a simple question. Are there any pins on a standard RAMPS 1.4 board where I can pick up 12V (to run an LED strip light)?

I know I could attach it to the 12V power supply plug, but then couldn't disconnect the PS from the printer w/out unscrewing the LED wires.

I know I could solder something to the board side of the 12V power receptacles, but I'd prefer not to.

Just wondering if there's 12V somewhere on the board with all of the additional connection points for accessories like servos, etc.

I currently have the LED strip attached to the D9 fan connections, but the voltage there fluctuates as the fan speed changes and as the extruder & bed heaters get turned on and off.

Thanks.