Results 21 to 22 of 22
Thread: FET Bed Heater Board
-
03-05-2016, 02:06 PM #21
- Join Date
- Jan 2016
- Posts
- 34
Got my printing doing some test prints today. On my third print of the day using PLA(60C bed) im about 2 hours in and the SMD board is staying below 90F. I have not changed from the stock relay sw configuration yet but it seems I over engineered my torture tests at work.
-
03-06-2016, 06:36 AM #22
- Join Date
- Jan 2016
- Posts
- 34
Got PID control setup on the Heated Bed, the switching frequency is much lower then I had expected (only 7.633Hz). Other then some hot wires(need to increase # of wires from ATX supply to bed) everything is nice and cool.
Do bed magnets deteriorate.
04-29-2024, 01:35 AM in General 3D Printing Discussion