Oxidation ?

[Fab]

Hi everyone !
In this video (of the early days) we can see some oxidation on the printboard, due to evaporation of salt water I guess.
Is it still a concern with the V1.0 ?
If so, is it possible to protect the peachy Printer from evaporation without altering the beam of the laser (plexiglass for example) ?

[Anuvin]

I had my printer mounted above an open container of saltwater for about 6 months, and I live about 3 miles from the ocean and I never saw any rust on anything. I wouldn't be concerned.

If you are very close to the ocean or your peachy is going to be very close to the reservoirs, you could put a rust inhibitor on the circuit board, being careful to avoid the laser. Heck, you could probably coat the entire board in silicone glue if you avoid the wire ports.

[rylangrayston]

Im glad to here that Anuvin!
It is often very dry here in Canada ( comes with the cold weather ),
We also have never had a problem on the printer head.
The dipper dose get crystals growing on it, but a quick rinse under warm water and its ready to go again.
Its a maintenance thing that we have just excepted.

[Fab]

Thanks guys for your answers.
Anuvin, I live indeed near the ocean (but on the other side ), and your experience is conforting.