Changed Something causing Spiral Diagnal lines on Walls - Possibly Slic3r setting?

[protechtrader]

Somewhere I must have changed something on my printer (Replicator Clone) causing a odd pattern of spiraling/diagonal lines on perimeter walls in all of my last prints. It has happened last 3 prints and I can not find the cause of it. Possibly a setting in Slic3r. Can anyone ID this problem? I am new, but I couldn't find similar problems searching and I cant figure out what it may be yet.

Any suggestions are appreciated.

WIN_20160109_08_37_15_Pro.jpg
Thanks

[kd7eir]

See if Spiral Vase is checked under Print Settings.

[protechtrader]

See if Spiral Vase is checked under Print Settings.

Unfortunately not. I determined it was a issue being created when gcode was translated to x3g with the heated bed temp gcode. I think I found the line with the issue, just need to do another test.