Problem with the "first Layer"

[Klonsoldier]

Hi Guys its me again,

i have a problem with the first outpush of the filament when the print starts... It is way to close on the bed and dont want to push smth out. Its get stuck on the side and pushes the printing away from the bed... Which setting is this on Cura ?!I tried bedZoffset but it didnt work..
thanks for the help !

[EagleSeven]

Hi Guys its me again,

i have a problem with the first outpush of the filament when the print starts... It is way to close on the bed and dont want to push smth out. Its get stuck on the side and pushes the printing away from the bed... Which setting is this on Cura ?!I tried bedZoffset but it didnt work..
thanks for the help !

Sounds like you just need to adjust the bed height,
with the 4 adjusting-screws under the bed.

[Klonsoldier]

I did this 4 times but didnt work... Oh and i have a similar problem like on of our members here. My printbed just "bended" and isnt leveled anymore. Its crooked. What causes this ?!

[EagleSeven]

I did this 4 times but didnt work... Oh and i have a similar problem like on of our members here. My printbed just "bended" and isnt leveled anymore. Its crooked. What causes this ?!

I suggest that you add a Glass plate to the bed.
That gives you a flatter, smoother surface and makes it easier to adjust.
(remove all tape and sand aluminum-plate before applying hair-spray
to attach glass to aluminum)
(3/32" is good thickness for glass)
(clamp glass to bed until spray dries)