Subscribe to Our Newsletter Advertise
Close



Results 1 to 3 of 3
  1. 12-31-2015, 01:45 AM #1
    pig2626
    pig2626 is offline
    Student
    Join Date
    Dec 2015
    Posts
    1

    Angry Reptier host connects to 3D printer but doesn't print?!?!?

    Hello the title pretty much explains it,
    So all I can print is a cube off the sd card and I don't have a sd card reader so I can't put any files on that.

    So I set the bruad rate correctly and all that, reptier host detects it and my computer but when I click print it says ETA and then printing but nothing happens
    Reply With Quote Reply With Quote
  2. 12-31-2015, 02:49 AM #2
    Mjolinor
    Mjolinor is offline
    Senior Engineer
    Join Date
    Jun 2014
    Location
    Burnley, UK
    Posts
    1,662
    So buy a card reader or flashair card. You shouldn't print over USB anyway, you will end up wasting plastic because the USB fails.
    Reply With Quote Reply With Quote
  3. 12-31-2015, 07:29 AM #3
    EagleSeven
    EagleSeven is offline
    Engineer EagleSeven's Avatar
    Join Date
    Jul 2015
    Posts
    553
    My guess is that the Slicer-software you are using is not compatible with the Firmware version in printer.
    I've seen that happen.
    Try Different Slicer-software !

    USB is Best ! SD is too much trouble !
    Our USB connection has Never failed !
    (Of course you Need a Good Printer, cable, software and Computer to get that Good connection)
    Last edited by EagleSeven; 12-31-2015 at 07:39 AM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules