Upturned corners, strings, and prints that look like they're melting.

[TiredJuan]

This might be a good way to get a fan shroud printed (so I can again print a better shroud.) Thanks for the tip.

[TiredJuan]

Alright, so heat is an issue. I intentionally spaced them semi-close to see if the shoulders that were closest would be problematic (They weren't.)
That being said, they weren't particularly great, and I had to press the corners down as suggested by EagleSeven, but it's definite progress.
20160103_093716.jpg20160103_093729.jpg20160103_093818.jpg20160103_093848.jpg
For those curious: this was printed with 10% infill, .27 layer height, with a single shell. Feed 30, travel 40, temp 190.