Subscribe to Our Newsletter Advertise
Close



Results 1 to 3 of 3
  1. 12-26-2015, 10:29 PM #1
    Crear4D
    Crear4D is offline
    Student
    Join Date
    Dec 2015
    Posts
    2

    Replicator 5th Generation stopped working

    Hi all,
    My 3D printer stopped working.
    Do not turn the control panel, this distinguished forum someone could give me some solution or clue about it?
    Attached Images Attached Images
    Reply With Quote Reply With Quote
  2. 01-10-2016, 11:42 PM #2
    hargakanay
    hargakanay is offline
    Student
    Join Date
    Jun 2015
    Posts
    2
    Have you taken the cover off? There's an HDMI cable that connects the front display to the electronics at the bottom rear of the printer. Might be worth checking to see if that's plugged in.
    Reply With Quote Reply With Quote
  3. 01-11-2016, 04:01 PM #3
    Crear4D
    Crear4D is offline
    Student
    Join Date
    Dec 2015
    Posts
    2
    Hi Hargakanay,
    Just check the HDMI cable is connected. The control panel does not turn, I think it was burned !!!
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules