Results 1 to 1 of 1
Thread: Ramps 1.4 on solidoodle press
-
12-02-2015, 08:54 AM #1
- Join Date
- Jun 2015
- Posts
- 6
Ramps 1.4 on solidoodle press
Hello,
I am having a lot of issues installing my ramps 1.4 in my solidoodle press. As far as hooking it up I have it finished. I am having issues with the firmware. I have tried multiple firmwares that are suppose to work, but I have not been lucky enough. I realize I will have to edit the sketch, which I have been doing, but the end stops will not work correctly and 2 of 4 extruders are not working correctly either. Has anyone installed a ramps in solidoodles press that could share a working firmware for a good base to start with?
Any help would be greatly appreciated.
Don
Do bed magnets deteriorate.
04-29-2024, 01:35 AM in General 3D Printing Discussion